How to Change Battery on iPaq 3800 and 3900 sequence

- Use prevalent perception treatment for dealing with the battery this kind of as not flexing (ie, bending), away from metal, away from intense heat, and so on.

- Make sure that all knowledge in iPaq have been backed up. All data will be misplaced following setting up the new battery.

- Study the entire instruction just before your initial endeavor to change the battery. This will enable you to visualize the approach just before it has begun.

one. Turn the energy off, and also make confident the reset critical on the bottom of the unit is turned off to make certain the electrical power is completely off.

two. Consider stylus out from iPaq in advance of proceeding.

3. Utilizing Torx T6 screwdriver, get the 4 screws off from every corner. Make sure not to misplace screws. Split the back cover from the major physique utilizing your fingernail or any flat kind machine these as a Phillips screwdriver. Just make convinced that you
do not scratch the floor if applying a screwdriver.

four. Once the back cover is split from the principal human body, open up the back cover from the leading. Do not pull it out all the way as the battery is attached to the key board via a versatile PCB connector. Take note: A, hard reset button slide door and stylus lock are not attached to the human body, and as a result, they could be free as the back again cover is pulled off. They are uncomplicated to place back but it is smart to just take a notice of their place and place.

five. As you pull the back again cover up gently, you will see a connector in between the battery and the most important board. Gently eliminate the connector from the battery. Please observe that the battery is glued to the back again cover, and can be eliminated just after you
disconnect the battery connector from the principal board.

six. After you have the old battery taken out, align the new battery so that the edge of the battery that is nearer to the connector goes to the bottom (ie, the taped aspect is the leading).

seven. Firmly press the connector to the battery. Make sure that all corners are inserted firmly.

8. Starting up from the bottom, reinsert the backcover. Do not power the cover when closing. This implies that the battery is not effectively seated onto the back again cover. Simply just realign the battery so that it is effectively seated.

nine. Place 4 screws again, and turn the reset critical and the power button on, in that order, to be certain that the unit operates normally.

10. You must fully recharge the battery, and go away it charged for additional thirty-60 minutes after a full cost indicator is on. This ensures that the battery is fully charged.

A complete guide with photographs are found at www.fusionteq.com

Motor vehicle batteries are very important for your vehicle as it is utilised to give energy through the auto. Seeing that they are also made use of for pretty a very long time, you should count on the want to change the car or truck battery in your car or truck for it to carry on to operate.

If you have to have to change your car battery, you have to know the techniques on how to adjust it.